Home Energy Audit: What a Real One Includes

A home energy audit is a measured look at where a house loses energy, done with a calibrated blower door and an infrared camera, and followed by a written report that ranks the fixes. In a Modesto home the findings usually point to air leaks, thin attic insulation and leaky ducts long before they point to a new air conditioner.

This guide explains what a real audit includes, how to tell it apart from a sales visit, what the U.S. Department of Energy says it costs, and how to turn the report into upgrades that fit MID rates and a Valley summer. It is part of our energy efficient home checklist.

What a real audit actually measures

The Department of Energy describes a professional assessment as “a much more detailed, equipment-based look at the energy efficiency of a house,” in which the assessor uses special equipment to measure the rate of air flow between the inside and outside (DOE Consumer Guide to Home Energy Assessments). The key word is measure. A walk-through with a clipboard is an inspection; an audit produces numbers you can compare before and after the work.

DOE names the two most common techniques as the blower door test and an infrared camera scan, “which are often done together.” During those tests the assessor may also inspect the heating and cooling systems, test for natural gas leaks and check whether the home is properly ventilated (same DOE guide). Those three extras matter as much as the headline tests, because a tighter house changes how air moves around gas appliances and how much fresh air the occupants get.

The blower door test

A blower door is a powerful fan mounted in a flexible panel that fits in an exterior doorway. It draws air out of the house, lowering the indoor pressure so that outdoor air flows in through every unsealed gap. With a smoke pencil, the auditor then finds where that air is entering. DOE adds a specific warning: make sure the assessor uses a calibrated blower door connected to a pressure gauge called a manometer, because blower doors without that measurement “can spot air leaks in the home, but not the amount of air leakage” (DOE).

That number is the point. A leakage figure taken before air sealing and again after it is the only honest proof that the sealing worked.

The duct blower

DOE notes that the assessor may also use a duct blower, a variable-speed fan attached to the duct system with a hose, to measure the amount of air leakage inside the ductwork. In a house with ducts in a hot attic, this is often the most useful test of the visit. A supply leak dumps cooled air into a space that can be far hotter than outdoors on a July afternoon, and a return leak pulls that attic air, and its dust, back into the system.

The thermographic scan

An infrared scanner shows temperature differences along walls, ceilings and around windows and doors as lighter or darker areas. DOE says that when the scan is done together with a blower door test, “air leaks show up as black streaks in the infrared image.”

Who should do the audit?

DOE advises using a certified energy assessor and suggests finding one through the local electric or gas utility, a state or local energy or weatherization office, or Home Performance with ENERGY STAR (DOE). The Residential Energy Services Network describes its HERS Index as “the nationally recognized system for inspecting and calculating a home’s energy performance,” and its certified raters work to a standard that includes procedures for measuring the airtightness of building enclosures and of duct systems (RESNET).

Ask any assessor four questions before booking:

  • Is the blower door calibrated and read with a manometer, so I get a leakage number and not just a list of drafts?
  • Will you test duct leakage with a duct blower?
  • Will you check the gas appliances and ventilation after the house is depressurized?
  • Will I get a written report with the measurements and ranked recommendations?

What does an audit cost?

DOE’s consumer guide says a professional home energy assessment “can cost from approximately $250 to $600 or more,” and that many contractors perform it at a reduced rate if they are hired for the upgrades that follow (DOE Consumer Guide to Home Energy Assessments). That is a national range from DOE, not a local quote and not this business’s price. What moves the figure is the scope: a blower door test alone is quicker than a visit that adds a duct blower, an infrared scan, combustion checks and a modeled report.

Low-income households may qualify for DOE’s Weatherization Assistance Program, the guide notes. Separately, MID lists a program discount, MID CARES, not a rebate: according to MID, it takes 60% off the $32.00 monthly fixed charge and 23.1% off the first 850 kWh for eligible households (MID Schedule D).

Why Modesto homes leak in summer

Most audit literature is written for cold climates, where the goal is keeping heat in. In Modesto the expensive season is summer. NOAA’s 1991 to 2020 normals for the city’s airport station put the July normal high at 95.0°F and August at 93.5°F, with an average of 7.0 days at 100°F or more in July and 4.8 in August (NOAA NCEI normals). On those afternoons, every leak lets hot air in and every duct leak in the attic throws away air the compressor has already paid to cool.

The housing stock makes this common. Census Bureau ACS 2024 one-year data puts the median year built for housing in Modesto at 1979, and by our count about 51% of units were built in 1979 or earlier (Census ACS via Census Reporter).

Electricity pricing turns that into money. On MID’s residential Schedule D, summer energy (May through September) costs $0.17759 per kWh for the first 500 kWh and $0.21349 per kWh above 500 (MID Schedule D, effective January 1, 2025). Every kWh above 500 in a summer month is billed at the higher rate. Our guide on how to lower your electric bill on MID rates walks through the tiers in more detail.

How should you prepare?

DOE suggests two simple steps before the assessor arrives: make a list of indoor problems you have noticed, such as condensation and uncomfortable or drafty rooms, and have copies or summaries of recent energy bills to share (DOE). For a Valley home, add a few summer notes:

  • Which rooms never cool down on a 100°F afternoon, and at what time of day they are worst.
  • Your May through September MID bills, since the summer tier is where savings show.
  • The age of the air conditioner, if you know it, and whether it runs nearly nonstop in July.
  • Whether the attic hatch is easy to reach, because the auditor will want to see the insulation and the ducts.

A do-it-yourself walk-through first

DOE describes a simple homeowner inspection as a walk-through focused on the places where air leaks occur. It lists spots where different materials meet, such as brick and wood siding, the joint between foundation and walls, and the areas around electrical outlets, switch plates, window and door frames, baseboards, attic hatches, wall or window air conditioners, vents and fans, and where electrical and gas service lines enter. It also suggests checking that caulking and weather stripping are in good condition (DOE).

Two DOE detection tricks need no equipment. At night, one person shines a flashlight over suspected gaps while a partner outside watches for rays of light. Or close a door or window on a sheet of paper; if the paper slides out without tearing, the seal is leaking. These find big gaps, not small ones, and they give no leakage number, so they are a way to start, not a substitute for the measured test.

One limit is our own safety advice, not DOE guidance. A depressurization test changes air pressure around gas appliance vents, so in a home with a gas water heater or gas heating equipment, we suggest leaving pressure testing to the assessor, who checks the appliances during the visit. Census figures show utility gas as the heating fuel in about 64% of occupied homes in the city (Census ACS), so this applies to most houses in town.

Reading the report and ranking fixes

DOE says the assessor should provide a report of the findings and ideas for improvements, and that the result may be as simple as sealing small gaps and adding attic insulation, or may show that bigger upgrades, such as replacing heating and cooling equipment, are cost-effective (DOE). A useful report ranks the work, and the usual order for a Valley home looks like this.

Order Fix Why it comes here
1 Air sealing Leaks are measured by the blower door, and sealing must happen before insulation covers the gaps.
2 Duct sealing Duct blower results show how much cooled air reaches the attic instead of the rooms.
3 Attic insulation Goes on after sealing; the infrared scan shows the thin and missing areas.
4 Ventilation check A tighter house may need planned fresh air; the assessor checks this.
5 Equipment Sized for the house after the first four, not before.

The order is the main thing an audit buys you. Sealing first makes the insulation work, and both together shrink the cooling load before anyone sizes a new system. Our guides to air sealing an older home before a new AC and attic insulation for pre-1980 Modesto homes cover the first and third steps.

Rebates that line up with the report

Check incentives against the report, not before it. MID’s 2026 Home Rebate Catalog pays 17¢ per square foot for attic insulation, but only where the home’s primary heat is electric, the existing insulation is R-11 or less and the final level is R-30 or more; homes heated with gas or propane do not qualify, and garages do not count (MID 2026 Home Rebate Catalog). MID applications must be made within 90 days of purchase, and the amount depends on funding on the date the application is received. MID’s central AC and heat pump rebates require installation by a CSLB C-20 contractor, a listing in the CEE directory and a copy of the city or county permit (same catalog).

Federal and state money has largely closed. The federal 25C credit is not available for equipment placed in service after 2025 (IRS), and TECH Clean California reports its heat pump incentives reserved statewide, with HEEHRA fully reserved and new requests on a waitlist (TECH Clean California).

Is an audit worth it before a new AC?

Usually, yes. The audit tells you whether the problem is the equipment or the house around it. A system that runs all afternoon in a leaky home may be doing its job; replacing it without fixing the house buys a new unit that runs the same way. When an audit does point to equipment, the measurements give the installer real numbers to size from.

When to call a professional

Homeowners can handle the walk-through, the paper and flashlight tests and simple caulking and weather stripping. Everything below is for diagnosis only, and the work belongs to a qualified technician:

  • Carbon monoxide. If a CO alarm sounds, or anyone has headache, dizziness or nausea that eases away from the house, leave the building first and call 911 from outside. Do not try to find the source.
  • Gas. A gas smell means leaving the house and calling for help from outside. Combustion appliance testing and venting checks after air sealing are the assessor’s or technician’s job.
  • High voltage. Air conditioners, air handlers and electrical panels carry dangerous voltage, and capacitors can hold a charge after power is off. Do not open them.
  • Attic work around wiring. Old wiring and recessed lights in the attic need checking before anyone seals or insulates around them.

For an AC or air handler that is part of the audit’s findings, AC Service Modesto can inspect the system and the ducts it serves. Call (209) 439-1859 or see our HVAC service in Modesto.

Frequently asked questions

What is included in a home energy audit?

A professional audit usually combines a calibrated blower door test, which measures how leaky the house is, and an infrared camera scan, which shows where the leaks and insulation gaps are. The assessor may also test duct leakage, check heating and cooling equipment, test for gas leaks and check ventilation, then provide a written report.

How much does a home energy audit cost?

The U.S. Department of Energy says a professional assessment can cost from approximately $250 to $600 or more, and that many contractors reduce the price if they are hired for the upgrades. Scope drives the figure, so ask what tests are included.

How long does a home energy audit take?

It depends on the size of the house and the tests included. A visit that adds a duct blower test, an infrared scan and appliance checks to the blower door test takes longer than a blower door test alone, so ask the assessor for an estimate when you book.

Can I do an energy audit myself?

You can do a useful walk-through, checking common leak spots and using the flashlight and paper tests DOE describes. A DIY check finds large gaps but gives no leakage number, and in a home with gas appliances the pressure testing should be left to the assessor.

Is a free energy audit worth it?

It can be, if it includes a calibrated blower door test with a measured leakage number and a written report. A free visit that ends with an equipment quote and no measurements is a sales call rather than an energy assessment.

The short version

A real audit measures leakage with a calibrated blower door, finds the leaks with an infrared camera, checks ducts, appliances and ventilation, and ends with a ranked report. In the Valley, with a 95°F July and MID’s upper summer tier, the report usually points to sealing, duct work and attic insulation first, and equipment last.