An indoor air quality test is only useful when it measures a specific pollutant with a known safe level. For most homes that means four things: carbon monoxide alarms, a radon test, a humidity reading, and a particle monitor for smoke and dust. “All-in-one” scores and mold air sampling rarely tell you what to fix.
This guide sorts home air tests into the ones that answer a real question and the ones that mostly sell a follow-up service. Each threshold below links to the agency that set it.
Start with the question, not the gadget
The EPA’s framework for better indoor air has three steps in order: source control, ventilation, then air cleaning, and it calls removing or reducing a pollution source usually the most effective approach (EPA, Improving Indoor Air Quality). A test is worth doing when its result changes which of those you do next.
The EPA also suggests a low-tech first step when someone feels unwell at home: note when and where symptoms occur, and whether they fade away from the area, which points toward an indoor source (EPA, Introduction to Indoor Air Quality). That diary costs nothing and narrows what you test for.
Common questions and the test that answers each:
- “Is anything in the house poisoning us?” Carbon monoxide alarms.
- “Is the ground under us a risk?” A radon test.
- “Why is the house musty, or so dry?” A humidity reading.
- “Is the smoke or dust getting inside?” A particle (PM2.5) monitor.
- “Is the paint or new furniture off-gassing?” Usually ventilation, rather than a test.
Carbon monoxide alarms come first
This is the one indoor air quality test every home with a fuel-burning appliance or attached garage should run around the clock. The EPA lists carbon monoxide sources including gas space heaters, leaking or back-drafting furnaces, water heaters, wood stoves and fireplaces, gas ranges, generators and vehicle exhaust from attached garages. It notes that higher levels cause headaches, dizziness, confusion and nausea, symptoms that may clear after leaving the building, and that CO is fatal at very high concentrations (EPA, Carbon Monoxide).
The same page cites the U.S. Consumer Product Safety Commission recommendation of CO alarms on each level of the home outside each sleeping area, and annual professional inspection of fuel-burning appliances. In Census data for Modesto, about 64 percent of occupied homes heat with utility gas (ACS 2024 1-year, via Census Reporter; the share is our calculation), so most local households fall in this group.
If a CO alarm sounds, leave the building immediately and call 911 from outside. An alarm is not a reading to investigate.
Radon is a test, not a guess
Radon is invisible and odorless, and the only way to know the level is to measure it. The EPA calls radon the number one cause of lung cancer among non-smokers and links it to about 21,000 lung cancer deaths a year. It cites the 2005 Surgeon General’s advisory to fix homes at 4 pCi/L or higher, puts the average indoor level at 1.3 pCi/L, and recommends testing (EPA, Health Risk of Radon).
Two practical notes. First, an air purifier does not solve radon; the EPA says it does not currently recommend air cleaners for radon (EPA). Second, most consumer “air quality” monitors do not measure radon at all, so a green score on one says nothing about it. A dedicated radon test does.
Humidity is the cheapest reading
An inexpensive hygrometer answers more household questions than most premium monitors. The EPA says indoor relative humidity should stay below 60 percent, ideally between 30 and 50 percent (EPA, Mold Course Chapter 2). The American Lung Association recommends keeping a home below 50 percent humidity to limit dust mites (American Lung Association).
Readings above 60 percent point to a moisture problem to fix at the source. Our guide on how to lower humidity in the house covers the summer side. In Modesto, with a July normal high of 95°F at the airport station (NOAA 1991 to 2020 normals), a working AC running through the summer usually helps hold humidity down. A persistently high reading in a cooled house is worth a look.
Particle monitors: useful, with limits
A PM2.5 monitor is the most useful consumer sensor in the Valley. The EPA Green Book lists all of Stanislaus County as part of the San Joaquin Valley nonattainment area for the 2012 PM2.5 standard (EPA Green Book, PM-2.5), and the EPA notes that indoor particle levels in homes without strong indoor sources tend to match or fall below outdoor levels (EPA, Indoor Particulate Matter). A monitor shows whether your house is keeping outdoor particles out on a bad day.
Use it for trends, not lab-grade numbers. The EPA describes air sensors as lower in cost, portable and easier to run than regulatory monitors, and runs a whole program comparing them against reference monitors to understand their accuracy (EPA, Air Sensor Toolbox). Good uses:
- watching the number fall after you close windows and start a purifier;
- seeing the spike when you fry, sear or light candles;
- comparing a reading with the fan on and off to spot a duct problem;
- checking a clean room during smoke, as covered in our air purifier for wildfire smoke guide.
To compare against outdoor conditions, use the AQI categories on AirNow, where 0 to 50 is good and 101 to 150 is unhealthy for sensitive groups.
Do VOC and “air score” readings help?
Many monitors show a total VOC number or a single color score. Treat those with caution. The EPA states that no federally enforceable standards have been set for VOCs in non-industrial settings, so there is no official line for a total VOC reading to cross (EPA, Volatile Organic Compounds). The same page says many VOCs run consistently higher indoors, up to ten times outdoor levels, and that levels after activities such as paint stripping can be far higher.
The answer to a high VOC reading is almost always the same: find the product, ventilate, and store or remove it. The EPA lists paints, solvents, cleaners, air fresheners, aerosols, hobby supplies and new furnishings as common sources. Formaldehyde is the exception the EPA notes “can be measured readily,” so a specific formaldehyde test is more meaningful than a total VOC number.
Is mold air sampling worth it?
Usually not as a first step. EPA’s mold guidance centers on moisture: “controlling indoor moisture will control the growth of indoor mold” (EPA, Mold Course Chapter 2). A musty smell, a stain or a humidity reading above 60 percent tells you where to look more reliably than a spore count. For mold reported inside ducts, the EPA says to ask the provider to show it, notes that a positive determination can be made only by an expert and may need lab analysis, and says wet or moldy duct insulation should be replaced, not cleaned (EPA, Should I Have the Air Ducts in My Home Cleaned?).
Testing the ducts themselves
Duct leakage is a measurable problem that affects both air quality and energy use. ENERGY STAR says about 20 to 30 percent of the air moving through a typical duct system is lost to leaks, holes and poor connections, and lists ducts in attics, crawlspaces or garages as a warning sign (ENERGY STAR, Duct Sealing). Leaks on the return side can draw in air from those spaces. A technician can pressure-test the system to measure leakage instead of guessing.
Which tests rarely pay off?
- Single “air quality score” visits that end in a product pitch. Ask which pollutant was measured, the reading, and the standard it was compared to.
- Ozone-producing “purifier” demonstrations. CARB strongly advises against ozone generators at home and requires indoor air cleaners sold in California to be certified (CARB, Air Cleaner Information for Consumers).
- Devices sold to “kill” pollutants. Our look at UV light for HVAC covers what those can and cannot do.
A simple testing plan for one year
Most homes do not need a lab. A practical indoor air quality test plan for a Modesto household can run on a short checklist through the seasons:
- Once: run a radon test, and retest if you remodel the lowest level or change how the home is sealed. Fix at 4 pCi/L or higher, per the EPA’s radon page cited above.
- Always on: CO alarms on every level outside sleeping areas, tested on the schedule the alarm maker gives. Replace them when the unit says it has reached end of life.
- Every season: check the hygrometer. In summer you want the AC holding the house under 50 to 60 percent; in winter, watch for very dry air below 30 percent, the bottom of the EPA’s ideal range.
- Smoke and dust days: watch the particle monitor against the outdoor AQI. If the indoor number tracks the outdoor one closely with windows shut, the house or the ducts are leaking.
- Every year: have fuel-burning appliances inspected by a professional, as the EPA’s carbon monoxide page advises, and change system filters on the manufacturer’s schedule, which the EPA lists among the ways to cut indoor particles.
Write the readings down. A log of dates, readings and what was happening in the house (cooking, cleaning, smoke outside, fan on or off) turns a cheap sensor into evidence. It is also exactly what a technician needs to see if you call for help, because it separates a real pattern from a single odd number.
When to call a professional
If a carbon monoxide alarm sounds, or people in the home share headache, dizziness, confusion or nausea that eases outside, leave the building immediately and call 911 from outside. Do not try to find or test the source yourself. Furnaces, water heaters and other gas appliances are diagnosed only by a qualified technician; homeowners should not open or adjust combustion equipment.
Call an HVAC professional for diagnosis when:
- a particle monitor climbs when the system fan runs, or rooms stay dusty right after cleaning;
- humidity stays above 60 percent with the AC running;
- you see soot or scorch marks near a fuel-burning appliance;
- you want duct leakage measured, or a filter upgrade checked against the blower.
Radon testing and mitigation are specialist work outside HVAC. AC Service Modesto can check airflow, filtration and duct leakage and explain what a reading means. Call (209) 439-1859, or see our indoor air quality service in Modesto. For how testing fits into sealing, filtration and running costs, read our guide on measuring indoor air quality at home.
Frequently asked questions
How do I check my indoor air quality?
Match the test to the question: CO alarms on every level outside sleeping areas, a radon test, a hygrometer for humidity, and a PM2.5 monitor for smoke and dust. Note when and where symptoms occur, which the EPA suggests as a first step to find an indoor source.
Does humidity affect air quality?
Yes. The EPA says indoor humidity should stay below 60 percent, ideally 30 to 50 percent, because moisture drives mold, and the American Lung Association links humidity above 50 percent to dust mites.
What is indoor pollution?
Gases and particles released indoors, which the EPA calls the primary cause of indoor air problems, plus outdoor pollutants that get in. Sources include fuel-burning appliances, cleaning and hobby products, building materials, excess moisture, radon and outdoor air.
Is a home indoor air quality test kit accurate?
It depends on what it measures. Radon tests and CO alarms target one pollutant with a known action level. Low-cost particle monitors are good for trends, and the EPA runs a program comparing sensors with reference monitors. Total VOC scores have no federal indoor standard to compare against.
The short version
A worthwhile indoor air quality test answers a specific question. Run CO alarms on every level, test for radon once, keep a hygrometer, and use a PM2.5 monitor for smoke and dust trends. Be skeptical of total VOC scores, mold air sampling without a moisture problem, and any test that ends in a sales pitch. A CO alarm means get out and call 911.